CIBIO® Single Panel Drug Test Dip card
Rapid Single Drug Test Strip is a rapid, screening test for the qualitative detection of single drug and drug metabolites in human urine at specified cut off levels.
The tests are intended for In Vitro Diagnostics use. They are intended for prescription use including point of care sites and over-the-counter use.
|Product Name||Single Drug Test Dip card|
|Brand Name||CIBIO® or OEM|
|Kit Contents||1. Test Dip card|
|3. Instruction for use|
|Assay Type||Qualitative Detection|
|Certificates||ISO 13485, 510K, CE, CLIA-Waived|
|Storage Temperature||4-30 degree centigrade|
|Shelf Life||2 years ( 24 months )|
|Delivery time||15-30 days|
|OEM Services||Pouch, Box, Private Label, Insert|
|Loading Port||Guangzhou or Shenzhen|
Drug Tests Available and Cut-off Levels
|1||Amphetamine (AMP)||500/ 1000 ng/mL|
|2||Barbiturates (BAR)||300 ng/mL|
|3||Benzodiazepines (BZO)||300 ng/mL|
|4||Buprenorphine (BUP)||10 ng/mL|
|5||Cocaine (COC)||150/ 300 ng/mL|
|6||Marijuana (THC)||25/ 50 ng/mL|
|7||Methamphetamine (MET)||500/ 1000 ng/mL|
|10||Morphine 300 (MOP)||300ng/mL|
|11||Opiate 2000 (OPI)||2000ng/mL|
|15||Tri-cyclic Antidepressants (TCA)||1000ng/mL|
|16||Ethyl -glucuronide(ETG)||300 or 500ng/mL|
|18||Synthetic Marijuana (K2)||50ng/mL|
How To Do The Test?
Test must be at room temperature 59-86°F (15-30°C).
1. Open the sealed pouch by tearing along the notch and remove the test dipcard from the pouch.
2. Hold the one side of the dipcard with one hand. Use the other hand to pull out the cap and expose the absorbent end.
3. Immerse the absorbent end into the urine sample for about 10 seconds. Make sure that the urine level is not above the line printed on the front of the device.
4. Lay the dipcard flat on a clean, dry, non-absorbent surface.
5. Read the results at 5 minutes. The drug test results remain stable for up to thirty minutes. See the illustration.
Reading The Results:
Preliminary positive (+)
A rose-pink band is visible in the control region, but no colored band appears in the test region. This indicates a preliminary positive result for this specific drug. Preliminary positive results must be sent to a lab for a more reliable test.
A rose-pink band is visible in the control region and the test region. This indicates that the drug is not present in the sample or is at a level that cannot be detected by this test.
If a color band is not visible in the control region, or a color band is only visible in the test region, the test is invalid. You should repeat the test with a new test dipcard. If the test still shows an invalid result, please contact us at 1-864-538-8007. When calling, be sure to provide the lot number for the test.
Note: There is no meaning to the colored line intensity or width. Any visible line is considered to be a line.
Certain lines may appear lighter or thinner than other lines.
ANY COLORED LINE VISIBLE IN THE TEST “T” REGION, NO MATTER HOW DARK OR FAINT, SHOULD BE INTERPRETED AS A NEGATIVE RESULT AS LONG AS THE CONTROL LINE IS ALSO PRESENT.
The test dipcard provides only a preliminary test result. All“preliminary positive” samples must be sent to a laboratory for a more reliable test.